The Mid-Autumn Festival and National Day holidays are approaching. First, I wish you a happy double festival and a wonderful time. But at the same time, don't forget to maintain our equipment. In order to ensure that the production can continue at a high speed and stability after the holidays, I suggest that everyone read the following content:
I.Equipment maintenance work before the holiday
After the equipment printing process is completed, check if the printhead is functioning properly, test the printing printhead with a test strip, and ensure that the status diagram is intact.
Before shutting down the machine, make sure that the ink nozzle of the printing machine is tightly and completely sealed against the ink tank. This will effectively keep the nozzle moist and prevent it from getting clogged.
Clean the used ink cartridge thoroughly. Use a clip to hold the waste ink tube in place, and tighten the cover that supplies ink to prevent air from entering.
Check if the dryer is turned off. Make sure the dryer is turned off and the power is disconnected.
The environmental temperature where the printing machine is stored should not be too low or too high.The environmental temperature where the printing machine is stored should not be too low or too high. If possible, it is best to keep the room temperature between 18℃ and 30℃, and the humidity at 35% to 65%. If possible, it is best to keep the room temperature between 18℃ and 30℃, and the humidity at 35% to 65%. Digital printing machines are sensitive to moisture. Digital printing machines are sensitive to moisture. In humid air, protective measures should be taken in advance to prevent the digital printing machine from getting damp and being damaged. In humid air, protective measures should be taken in advance to prevent the digital printing machine from getting damp and being damaged.
Cover the printing machine with a dust cover to prevent dust from contaminating the equipment. Place it in a safe location. Take measures for fire prevention, water resistance, theft prevention, rodent prevention, and pest prevention to avoid damage to the equipment due to abnormal reasons.
If the inkjet printer's nozzle is not used for a long time, it may get clogged. If possible, it is recommended to arrange for a duty staff member to print a nozzle test strip every 3 days to check if the nozzle is clogged. If it is clogged, a cleaning operation should be carried out to ensure the nozzle is in the best condition.
II.Maintenance work for the equipment after the holiday
Before starting the digital printing machine, it is necessary to ensure that the working environment of the equipment reaches the optimal temperature and humidity. The specific temperature range is 18℃ - 30℃, and the humidity range is 35% - 65%.
Please carefully inspect the printing machine and ensure that all components are properly installed.
Air pressure check: Verify if the air pump's air pressure is normal.
Print platform inspection: Ensure the print platform is free of any foreign objects to prevent scratches and damage to the nozzle.
Waste ink tank inspection: Check the liquid level of the waste ink tank to prevent it from overflowing and spilling during cleaning.
Ink check: Ensure that the ink in the ink cartridge is sufficient to prevent the nozzle from running out of ink, which could cause damage or blockage to the nozzle.
Scraping test: The scraping sheet should be kept clean and undamaged to prevent any interference with the ink scraping process.
After turning on the machine, print the test strip to check if the nozzle is functioning properly.
Cautionary Notice
If a digital printing machine is not used for a long time, any blockage in the printhead will lead to many "complications", such as oblique printing, ink flying, and needle deviation, which will shorten the lifespan of the printhead. In severe cases, it may even cause the printhead to be scrapped. Therefore, special attention should be paid to the maintenance of the digital printing machine.
